HR-50 & HR80 Hot Runner Controller

HR-80 | HR-50 series

 

  • Soft start – extended function of drying heaters at lower supply voltage. During soft start the leakage current from the heater to the ground is measured. This function protects the heater from burnout (a wet heater will not be switched on).
  • Automatic emergency mode – when heat sensor has been damaged, temperature controller automatically switches off. And, with error message when fuse burn-down / Heater break / Thermocouple break, short, open and reverse wiring.
  • Two operation modes – Auto-tunning for normal operating or Manual to allow power output to be adjusted manually.
  • Multi-indications – Dual display for PV & SV / Temperature unit °C or °F/Output / Alarm / Soft start / Auto-tunning…
  • Boost mode – with display for temporary % of power output and output current.
  • Universal power – Voltage 85-265VAC (50/60Hz)

Products Specification

Model No.HR-501HR-502HR-503HR-504HR-506HR-508HR-510HR-512
ZONE Number1 zone2 zones3 zones4 zones6 zones8 zones10 zones12 zones
Output factory per zone220V 3500W
16 Amps
220V 3500W
16 Amps
220V 3500W
16 Amps
220V 3500W
16 Amps
220V 3500W
16 Amps
220V 3500W
16 Amps
220V 3500W
16 Amps
220V 3500W
16 Amps
SSR Output
or
RELAY Output
250VAC 25A
or
250 VAC 16A
250VAC 25A
or
250VAC 16A
250VAC 25A
or
250VAC 16A
250VAC 25A
or
250VAC 16A
250VAC 25A
or
250VAC 16A
250VAC 25A
or
250VAC 16A
250VAC 25A
or
250VAC 16A
250VAC 25A
or
250VAC 16A
Output Connector16 Poles
400V 16A
10 Poles
400V 16A
16 Poles
400V 16A
16 Poles
400V 16A
24 Poles
400V 16A
16 Poles
400V 16A
24 Poles
400V 16A
24 Poles
400V 16A
BreakerXX3P 415V 63A3P 415V 63A3P 415V 63A3P 415V 63A3P 415V 63A3P 415V 63A
Power Cable1⌀ 2P 220VAC
3.5mm²x3C
4M long
1⌀ 2P 220VAC
3.5mm²x3C
4M long
1⌀ 2P 220VAC
3.5mm²x3C
4M long
1⌀ 2P 220VAC
3.5mm²x3C
4M long
1⌀ 2P 220VAC
3.5mm²x3C
4M long
1⌀ 2P 220VAC
3.5mm²x3C
4M long
1⌀ 2P 220VAC
3.5mm²x3C
4M long
1⌀ 2P 220VAC
3.5mm²x3C
4M long

Downloads

HR-50 & HR80 Hot Runner ControllerFY Microprocessor Controller

Product Enquiry